Crestron TPS-1700 Specifications download pdf (Page 17)

Crestron TPS-1700 Isys

™

Wired 5.7 Inch Tabletop Touchpanel

Operations Guide - DOC. 6117 Isys

™

Wired 5.7 Inch Tabletop Touchpanel: TPS-1700 • 13

TPS-1700 Symbol in Programming Manager

Programming Manager is where programmers “program” a Creston control system

by assigning signals to symbols. The graphic on the next page shows the TPS-1700

symbol in the SIMPL Windows’ Programming Manager.

Detail View of the TPS-1700 in SIMPL Windows’ Programming Manager

Signal Types

Signals interconnect the various devices and logic symbols that comprise a SIMPL

program. Signals can be one of three types: digital, analog, or serial. For any given

signal, the signal type is determined by its driving source. That is, if the symbol that

drives the signal has an analog output, then, by definition, the signal connected there

will be an analog signal.

In SIMPL Windows, the signal types are color-coded as follows:

Digital = Blue

Analog = Red

Serial = Black

Other = Green

NOTE: “Other” signals are a combination of the three basic types (e.g. many

symbols accept either analog or serial signals where the combination is shown as a

green signal). The signal type is displayed on the Status Bar when the signal is

highlighted.

For additional information, refer to Doc. 6120, Crestron SIMPL Windows Symbol Guide. It

may be downloaded from the Downloads | Product Manuals | Software section of the Crestron

website (www.crestron.com)

Digital Signals

A digital signal contains one bit of information and usually takes on one of two

values: 1 or 0. These two digits can represent the logical values true and false, and

they can be represented in an electronic device by the states on/off or high/low,

recognized as two voltage levels. (Other common descriptors are active/inactive.)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

No comments

Crestron TPS-1700 Specifications Page 17