Crestron QM-RMCRX-BA Specifications download pdf (Page 14)

QuickMedia™ Receiver/Processor Crestron QM-RMCRX-BA

Front Panel Ports

The QM-RMCRX-BA front panel ports are illustrated and described as follows.

QM Input

The eight-pin RJ-45 QuickMedia transport port accepts CAT5E audio, video,

microphone, and control signals. The QM input port conforms to the 568B

wiring standard. The associated QM LINK LED indicates a QM connection.

Refer to page 16 for network wiring information and refer to page 6 for

pinouts.

24 Y Z G

NET

24 Y Z G

NET

These connectors are used for expansion to Cresnet peripherals. Power to the

unit can be supplied through this connector. The associated NET LED

indicates network activity.

24 VDC

2.0 A

24VDC, 2.0A (Power Supply Input)

This male connector can be used to supply 24 VDC power to the

QM-RMCRX-BA from an external power pack (included).

CAUTION: Use only Crestron power supplies for Crestron equipment.

Failure to do so could cause equipment damage or void the Crestron warranty.

LAN

Yellow

Green

LAN

An 8-position RJ-45 port (labeled LAN) is used for connection to the

Ethernet, providing local area network or Web access (cable is not supplied).

The port also contains two light-emitting diodes (LEDs). The green LED on

the right side of the port is a link status LED and illuminates when the card is

connected to a working network. The yellow LED on the left side flashes to

indicate Ethernet activity. Refer to page 22 for Ethernet cabling details.

SPEAKER

+ -

SPEAKER

The speaker output consists of two 2-pin terminal block connectors, 5 mm

spacing. These connectors have left and right amplified stereo audio output,

10 watts per channel into 4 or 8 ohms.

10 • QuickMedia™ Receiver/Processor: QM-RMCRX-BA Operations Guide - DOC. 6332

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 75 76

No comments

Crestron QM-RMCRX-BA Specifications Page 14