Crestron QM-RMCRX-BA Specifications Page 59

  • Download
  • Add to my manuals
  • Print
  • Page
    / 76
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 58
Crestron QM-RMCRX-BA QuickMedia™ Receiver/Processor
Audio Mixer Signals (continued)
SIGNAL TYPE
AND NAME
DESCRIPTION
Analog inputs
<Mic2EQTrim1>
through
<Mic2EQTrim4>
These signals have NO effect if automatic audio compensation is enabled.
Sets the four MIC 2 EQ trims (at 160Hz, 500Hz, 1.2kHz, and 3kHz).
Valid analog values range from -120d (-12dB) to +120d (+12dB), adjustable in
increments of 0.1dB (1d = 0.1dB).
A trim of 0d (0dB) means that the signal will pass unaffected.
Out of range values will clip the trim to the minimum or maximum value.
Analog outputs
<Mic2EQTrim1_F>
through
<Mic2EQTrim4_F>
Indicates the trim being applied to each band of the MIC 2 equalizer.
Slot 8: C2I-RX-GENAUDIO-AUTOCOMP
The General Audio Controls module is built into slot 08 (with auto
compensation). Refer to Appendix B on page 65 for additional auto
compensation information.
The QM-RMCRX-BA provides one QM input labeled QM that receives four
channels of digital audio as follows:
The two channels of stereo program audio are referred to as LEFT and
RIGHT.
The two microphone channels are referred to as MIC 1 and MIC 2.
The unit provides the following audio outputs:
One line-level output labeled AUDIO with three channels labeled L, R
and SPCH. Each channel provides muting, volume and tone controls.
One powered amplifier output labeled SPEAKER with two channels
labeled L and R. The SPEAKER output duplicates the AUDIO L and R
outputs and allows speakers to be connected directly to the
QM-RMCRX-BA.
The QM-RMCRX-BA supports up to 192 source gain compensation presets,
which allow for normalization of audio levels between different sources.
When auto-compensation is enabled (by setting the <EnableAudioAutoComp>
input high), the audio compensation presets are not used. Instead, the audio
compensation value stored at the QM transmitter for the selected audio source is
propagated to the QM-RMCRX-BA.
NOTE: Mic tone settings apply equally to both microphones.
Operations Guide – DOC. 6332 QuickMedia™ Receiver/Processor: QM-RMCRX-BA 55
Page view 58
1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 75 76

Comments to this Manuals

No comments